Category Archives: Installation Guide

The position of the cube should be adjusted according to design. There are several situations: 1.Only cube: Let the eadge of the entrance hole align to the pillar, easier to enter. 2.Cube connect to tunnel: install panel to pillars, install tunnel to panel, connect cube to tunel. 3.Cube with a gate panel: install panel toContinue reading “Installation of plastic cube for indoor playground”

Below give steps of installation. We will provide detailed instruction after playground delivered. First step: install EVA mats. Put EVA mats on floor, put a protection film above mats for protect mats during installation. Remove that after playground complete. Second step: install metal frame and parts attached to metal frame. We will send detailed drawingContinue reading “Installation guide of indoor playground”

Need patient and method to make pipe cover fit frame perfect and looks fantanstic, installation of soft pipe protection cover is very detailed decoration work. Standard soft pipe protection cover length 2.5 meters, inside diameter 5cm, outside diameter 8cm. Install pipe cover for all pillars first, leave the horizontal pipes at the last. How toContinue reading “Soft pipe protection cover of indoor playground”

There is easy way to finish safety net fast and good. Width of safety net is about 3 meters Wrape the wall of the playground, cut the extra side net during instlallation if height of playground smaller than 3 meters. But remember, cut safety net straightly, so as to get perfect nice safety net installation.Continue reading “Safety net of indoor playground”

PLASTIC STAIGHT SLIDE Drill hole on the head of slide. Drill the same distance hole on pipe (measure and mark the distance before drilling). Connect them by bolts. ( Put slide down after finish this step, leave long bolts on pipes, put slide back after safety net and soft protection pipe cover complete) GATE OFContinue reading “Straight plastic slide for indoor playground”

Parts and Run Parts: One Locomotive, Three Carriages, One Control Box . Work: Input AC 220V electricity, transform to DC 24V by control box, then output to railway. Assembly 1.Install Track: there is number at two side of each track, like A1, B2 etc, Connect A1 to A1, B2 to B2. Leave one part ofContinue reading “Manuel of electrical train with track”

We test installation of tunnel slide before delivery. It divide to several parts after make mark on tunnel. Mark like A1, A2… at the connect position of one parts, the same mark A1, A2 at the other parts, just connect those parts by align the mark and bolts them together. You should install from topContinue reading “How to install tunnel slide”

There are two type to install balance beam. First type: There are 8 pipes as the frame structure of balance beam, 2 pipes under beam as support, 2 horizontal pipes and 4 inclined pipes as fence, a webbed net for protection. Installing the webbed net when install those pipes, because net should be plug intoContinue reading “Balance beam at indoor playground”